Pvc Dip Coating Plastisol, Pvc Dip Coating Plastisol Manufacturer, Pvc Dip Coating Plastisol Supplier, Mumbai, India
ARMA PLAST

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

 

PVC DIP Coating Plastisol

 

Description :
PVC Dip Coating Plastisol, specially formulated for coating electroplating jigs, hand tools and other metal coating applications.
 
Technical Specifications :
Type
:
Dip Coating Plastisol
Colour
:
Black / Red / As per requirement
Appearance
:
Viscous liquid.
Viscosity 
( Ford cup No.8 at 300C)
:
80 to 100 Sec.
Specific Gravity
:
1.60 to 1.70
Hardness (Shore A)
:
60 to 65
Chemical Resistance
:
To Acid, Alkali, Aliphatic Hydrocarbon & Alcohol.
Reducer recommended
:
Reducer for plastisol
 
Application :

A typical cycle for hot dip coating is as follows :
1.  Clean and degrease the metallic article.
2.  Preheat the article in an over at 170 to 1900C for 7-12 min.
3.  Dip the hot article in dip coating plastisol at the rate of 20cm/minutes.
4.  After a dwell time of 30 seconds slowly withdrawn the article form the plastisol
     bath at the rate of 10 to 12cm / minutes.
5.  Allow excess dip coating plastisol to drain off.
6.  Suspend the article in the oven and cure at 180 to 2000C for 20 to 30 minutes.

To obtain a thick coating, semigle the first coat at a lower temperature of 140 to 1500C for 5 to 10 minutes, and repeat the complete cycle (steps 4 to 6)

It should be noted that thickness of coating is controlled by degree of preheating and the duration the article remaining in the dip coating plastisol tank.

Uses : Dip Coating Plastisol used for coating metallic articles like electroplating jigs, wire baskets, dish drainers, racks, ducks, gratings, rods, handles etc.

Packing : 25 Kg and 50 Kg containers.

Storage : Dip Coating Plastisol have tendency to thicken ( Increase in viscosity ) on standing and therefore should be stored in a cool and dry place.

Shelf Life : Six months under normal temperature conditions.

 
 
 
PVC Caps   |   Rectangular Cap And Taper Cap    |    PVC Grips    |   PVC Sleeves    |    PVC Shrouds   |   
PVC Covers    |   PVC Coating Work    |   Plastic End Caps    |   Plastic Protective Caps
 
 
Home    |    Profile    |    Introduction    |    Products    |    Contact    |    Enquiry
Designed & Hosted By : MID     Promoted By : GID